1INSTALLATION &OPERATIONMANUALEXCALIBUR® LIGHTBARSRead all instructions and warnings before installing and using.INSTALLER: This manual must be de

10STROBE LIGHTING CONNECTIONSPOWER CONNECTIONFor all configurations the strobe power supply(s) will be powered by the #16AWG RED, and/or RED/BLK wires

11STATIONARY LAMPS/TAKEDOWN LIGHTS - A stationary reflector assembly used for ArrowStik flashing,takedown, and/or work light applications. These are

12Figure 7S-795 (Bayonet Style): Push down and turn toremove lamp. Install a new lamp the same way.Note: If attempting to clean the reflector, use

13Electronics Module RemovalIn the event that the power supply or a strobe lighthead assembly must be returned to the factory for service, mark each w

14FIGURE 94-Head Power Supply6-Head Power Supply+12VDC (Red)+12VDC (Red)Ground Wire (Blk)Ground Wire (Blk)Control Wire Harness(Yel/Blk,Brn

15FIGURE 10FIGURE 116.003.054.0010.95.4003.30

1664591037218EXCALIBUR EXPLODED VIEW7

1711 12131415161817Note: All screws are part no. 1215 unless otherwise indicatedFIGURE 12

18Parts List(Reference numbers identify items shown in Figures on previous pages)Ref No. Description Part No.8 #8 x .250" Sheet Metal Screw T0502

1913 Excalibur 20W Halogen Stationary Module S50849Excalibur 27W Halogen Stationary Module S50850Excalibur 28W Incandescent Stationary Module S5085110

2IntroductionThe Excalibur® Light Bar is a dual-level light bar that is approximately 4 1/2" high, yet delivers unobstructed 360° warningand more

20STROBE OPTIONTROUBLESHOOTING GUIDEPROBLEMLight heads do notfire.Only front strobesflash.Led modulewon't DimCAUSEa. Harness that connects powers

21PROBLEMArrowStik does notfunction when turnedonLamp does not comeon when it should.Right most lamp doesnot come on in ArrowLeft mode or left mostlam

22NOTES

23NOTES

24Code 3 is a registered trademarkof Public Safety Equipment, Inc.Revision 10, 07/05 - Instruction Book Part No. T05075©2005 Code 3®, Inc. Printed i

3Unpacking & Pre-installationCarefully remove the light bar and place it on a flat surface, taking care not to scratch the lenses or damage the ca

4FIGURE 2Vehicle RoofVehicle GutterCurved Feet onCurved PortionThe shims provided may be used here to help level the light bar, see Figure 1. Also, t

5FIGURE 4Once the light bar is level and centered, mark the holes through the mounting tabs and remove thelight bar from the vehicle. Make sure that

6OPTIONAL STROBE WIRING INSTRUCTIONS - For all configurations the strobe power supply(s) will be poweredby the #14 AWG Red and Red/Black wires in the

7Dim OperationLightbar LED modules are equipped with a low power "Dimming" mode as standard. Dimming will be controlled byapp

8Master/Slave OperationEach 360 degree corner module consists of a "master" and a "slave" driver circuit board, 360 degree optics

9Directional module Flash Pattern - Table 2Flash Pattern DescriptionCycle Flash Cycles through various patterns @ 70 fpmSteady-Burn Steady-BurnFive Fl