Code-3 Code 360 Bedienungsanleitung PDF herunterladen (Seite 13)

Figure 7

The following are optional features that may or may

not be included in your control head depending upon

which model you purchased.

"Fast Speed" Mode: Fast speed and Dim Modes

are combined. Pushing the button marked "Fast" will

cause each of the 4 patterns of the ArrowStik to

operate at a faster rate, with the same amount of light

intensity.

"Dim" Mode: Dim and Fast speed Modes are

combined. Pushing the button marked "Dim" will

cause each of the 4 patterns of the ArrowStik to

operate at a lower intensity level. This is for use at night

when 100% intensity is too much, or daytime when current

draw needs to be reduced.Bayonet Style: Push down and turn to

remove lamp. Install a new lamp the same way. (SEE FIGURE 7)

Note: If attempting to clean the reflector, use only a mild glass cleaner and a very soft cloth. Do not attempt to use any wax type

products as these will burn onto the reflector.

Changing Lower Unit Lamp and/or Filter

Refer to Figure 10. Remove the reflector assembly by removing the appropriate fasteners, then remove the snap-on filter if

necessary. In most cases, these lamps will be a bayonet style, so simply push in and turn counterclockwise to remove.

Replacement for Upper and Lower Level Components

See exploded view "Parts Section" for fastener removal, component location, and assembly

configuration. Caution, extreme care must be taken when installing components to prevent pinching wire connections

and to avoid interference with moving assemblies.

WARNING!

High voltages and/or temperatures are present inside the unit. Disconnect from power and wait 10 minutes

prior to servicing or troubleshooting. Use hand and eye protection when changing halogen lamps or

flashtubes.

Strobe Filter Replacement

Refer to figure 8. The filter can be removed by unsnapping it from the light head and by removing the mirror if present for clearance. Prying

the filter from the front may damage the glass strobe tube or reflector.

To replace the filter, reverse the above procedure. The filter should be fully engaged on the light head assembly. Care should be taken to

not damage the strobe tube or to scratch the reflective surface of the reflector when replacing the filter.

Strobe Light Head Replacement

Refer to figure 8. Disconnect the light head assembly wiring from the strobe power supply and remove the filter if any. Unfasten the screws

attaching the light head mounting bracket to the light bar chassis and remove the light head from the light bar. On a bench or other work

suitable work surface unfasten the screws attaching the strobe light head assembly from the light head mounting bracket. Install the new

strobe light head assembly to the light head mounting bracket and reinstall the light head back onto the light bar chassis. Reconnect the light

head wiring to the strobe power supply and reattach the filter. It is important to reroute and secure the wiring as close as possible to its

original position.

Caution, verify that no wires are interfering with the operation of the fan located at the end of the power supply.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 23 24

Keine Kommentare

Code-3 Code 360 Bedienungsanleitung Seite 13