Code-3 FM 9000 Bedienungsanleitung PDF herunterladen (Seite 5)

LED MODULES

The LED modules are available as “flashing” and “steady burning” versions. The steady burning

versions can be flashed by connecting the module(s) to any flasher that does not require ground

through the load (example: Code 3® 925 or 700 series relay flasher). The flashing modules will

have "Cycle flash" as the standard pattern. Flash patterns can be changed by shorting the 2-pin

header, J1 as shown in Figure 3, momentarily then releasing. PLEASE NOTE THAT THE

LIGHTHEAD MODULE MUST BE REMOVED FROM THE FRAME TO EXPOSE THE J1

HEADER. Table 1 shows the available patterns and the order when stepping through patterns. The

module can be reset to "Cycle flash" by shorting the header for greater than 5 seconds and

releasing.

FIGURE 3

Directional Module Flash Pattern - Table 1

Flash Pattern Description

Cycle Flash Cycles through various patterns @ 70 fpm

Steady-Burn Steady-Burn

Five Flash Five Pulses per flash @ 70 fpm

Quad Flash Four Pulses per flash @ 70 fpm

Triple Flash Three Pulses per flash @ 70 fpm

Double Flash Two Pulses per flash @ 70 fpm

Fast Double Flash Two Pulses per flash @ 85 fpm

NFPA Four Pulses, 70% Duty Cycle @ 75 fpm

Quad Pop Flash Four Pulses per flash ( 3 equal, 1 extended) @ 70 fpm

Triple Pop Flash Three Pulses per flash ( 2 equal, 1 extended) @ 70 fpm

PCB

Momentarily short and release

to change patterns

1 2 3 4 5 6 7 8 9 10 11 12

Keine Kommentare

Code-3 FM 9000 Bedienungsanleitung Seite 5