Code 3 SuperVisor Wartungshandbuch PDF herunterladen (Seite 4)

Step 6 Mounting the SuperVisor Outer Mounting Brackets

While pushing up on the SuperVisor's Outer Panel under each of the inner mounting brackets, tighten each of the 1/4-20 bolts (see Fig-

ure 15). The idea is to close up any gaps between the vehicle's headliner and the headliner edge of the SuperVisor so that the light from

the light bar doesn't leak through. Again while pushing up on the SuperVisor's Outer Panel under each of the outer mounting brackets,

tighten each of the 1/4-20 bolts (see Figure 16).

Step 5 Mounting the SuperVisor® Inner Mounting Brackets (Driver side shown)

Place the Driver side inner mounting bracket on the Driver side retaining clip and orient as shown in Figures 10 and 11. Attach the

inner bracket and retaining clip to the headliner as illustrated in Figure 12. Do not fully tighten the screws at this time. Repeat these

steps for the Passenger side Inner mounting bracket. Next line up the mounting holes in the Inner mounting brackets with the thread-

ed holes in the SuperVisor and loosely thread the supplied 1/4"-20 bolts and internal tooth lock washers in the SuperVisor's Outer

Panel (see Figure 13). Line up the mounting holes in the outer mounting brackets with the threaded holes in the SuperVisor and

loosely thread the supplied 1/4"-20 bolts and internal tooth lock washers in the SuperVisor's Outer Panel (see Figure 14). Tighten the

two #2 Phillips Head screws in each of the two outer Pivot Brackets (see Figure 9 again). Tighten both of the inner mounting bracket

screws (see Figure 12 again).

FIGURE 10 FIGURE 11 FIGURE 12

FIGURE 13 FIGURE 14

Step 4 Attach the pivot arm brackets

Attach the outer mounting brackets that are supplied noting the difference between passenger and driver side brackets (see Figure 7

-Driver side shown). Rotate the pivot arm bracket on the Driver's side sun visor and verify that the orientation of the outer mounting

bracket is as shown in Figure 8. Position the Driver's side pivot arm and attach the rst Phillips screw as shown in Figure 9, then install

the other Phillips screw. Repeat this operation for the Passenger side pivot arm and outer bracket. Do not tighten any of the screws at

this time.

FIGURE 7 FIGURE 8 FIGURE 9

1 2 3 4 5 6 7 8 9 10 11 12

Keine Kommentare

Code 3 SuperVisor Wartungshandbuch Seite 4