Code-3 Sprinter Bedienungsanleitung PDF herunterladen (Seite 16)

PROGRAMMING STEP #7:

ENABLES PROGRAMMING OF THE EMERGENCY key:

the following keys will be illuminated:

EMERGENCY (will be illuminated Indicating Step #7 in Pressing any key

along with other any programming mode. in EMERGENCY

other keys programmed programming mode

into the light list.) will include that key

function in the list

of functions for the

EMERGENCY key.

Headlight Flasher:

If the vehicle is equipped with a headlight asher, pressing both the left and right arrow keys

at the same time will enable this function when the EMERGENCY key is selected and will

illuminate the ALT key to indicate such.

Intersection Lights:

If the vehicle is equipped with intersection lights, pressing both the SEC & TAKEDOWN keys

at the same time will enable this function when the EMERGENCY key is selected.

(No indication is displayed for this function.)

Changing the initial condition of the SIREN tone from WAIL to YELP

Can be done by pressing the key to the following conditions:

WAIL/YELP key; Illumination condition: OFF Indicates: Siren tone off

Illumination condition: ON Indicates: setting to WAIL tone

Illumination condition: FLASHING Indicates: setting to YELP tone

When nished

press ALT to save

settings or to exit

without saving press

CLEAR.

TROUBLE SHOOTING:

PROBLEM PROBABLE CAUSE REMEDY

No siren output shorted speaker or speaker wires check connections and wire ways

Fuse Blows amplier wires reversed polarity check polarity of wire connections

Siren tone volume low or garbled low voltage to siren amplier, high

resistance in wiring/ defective spkr.

check wiring for bad connections,

check spkr wiring, replace speaker

High rate of speaker failures high voltage to siren, 58 W speaker

connected-(58 W spkr not allowed)

check vehicle charging system,

install 100W speaker in system

Backlight will not light or adjust parklight input must have +12V for

backlight to function on controller

engage parklights on vehicle if

wired into system. or apply +12V.

to parklight circuit input on Amp.

Auxiliary lights do not operate IE:

alley, TD , sign board, headlight

ashers

short ciruit of wiring for light in

question, internal fuse blown in

amplier

check wiring and connections to

lights in question, check and re-

place fuse in amplier circuit

1 2 ... 11 12 13 14 15 16 17 18 19 20

Kommentare zu diesen Handbüchern

Keine Kommentare

Code-3 Sprinter Bedienungsanleitung Seite 16

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Für das Auto Code-3 Sprinter