Code-3 SuperVisor_3Up_OPTIX_2011_Ford_F150 Bedienungsanleitung PDF herunterladen (Seite 6)

Troubleshooting

All SuperVisorTLs are thoroughly tested prior to shipment. However, should you encounter a problem during installation or during the

life of the product, follow the guide below for information on repair and troubleshooting. Additional information may be obtained from

the factory technical help line at 314-996-2800.

Follow the guide below for information on repair and troubleshooting.

TROUBLESHOOTING GUIDE

Note: LED modules must be replaced as a module. There are no user serviceable parts.

PROBLEM

LED module not

operating when

powered.

QUESTIONS POSSIBLE CAUSE

a. Bad power/ground

connection.

b. Defective module.

SOLUTION

a. Fix connection.

b. Replace module

N/A

Directional module Flash Pattern - Table 2

CycleFlash (DEFAULT) Quad Pop Flash75

NFPA QuadFlash75 Triple Pop Flash75

Steadyburn SingleFlash375

ModelFlash SingleFlash250

ActiveFlash SingleFlash150

FiveFlash70 FiveFlash150

QuadFlash70 QuadFlash150

TripleFlash70 DoubleFlash150

DoubleFlash70 TripleFlash150

SingleFlash75

Flash Pattern Header for OPTIX

Momentarily short and release

to change patterns

PCB

Changing Flash Patterns

To change the ash patterns on the LED Light Heads, remove the mounting screws that attach the SuperVisor's Cover to the Outer

Panel to gain access to the printed circuit boards inside (see the exploded view on page 7). Momentarily short and release the pat-

tern change prongs as shown below to change patterns. Carefully replace the SuperVisor's Cover over the Outer Panel and replace

the Cover Mounting Screws.

Note: Be extremely careful to replace the wiring such that you don't pinch a wire when you replace the Super-

Visor's Cover. Test the unit to be sure that it works properly.

1 2 3 4 5 6 7 8

Keine Kommentare

Code-3 SuperVisor_3Up_OPTIX_2011_Ford_F150 Bedienungsanleitung Seite 6