Code-3 WingMan for Chevy Impala Bedienungsanleitung

INSTALLATION& OPERATIONMANUALWingMan™Introduction...

10W ARNING!PROBLEMLED module notoperating whenpowered.POSSIBLE CAUSEa. Bad power/groundconnection.b. Defective module.SOLUTIONa. Fix connection.b. R

11

12Parts ListReference Number Part Description Part Number 1 Outer Panel Long Version T09651Outer PanelShort Version T06590 2 *

132006 Installation InstructionsObserve position of mounting holes.Shown in figure A.FIG. ADrill the 2 mounting holes through the rear deck.Shown in f

142006 Installation Instructions cont.FIG. CFIG. DInsert the carriage bolt through the mountingfoot and rear deck. Place the fender washerand lockwas

15Notes

WARRANTYCode 3®, Inc.'s emergency devices are tested and found to be operational at the time of manufacture. Provided they areinstalled and oper

2Unpacking & Pre-installationCarefully remove the WingMan™ and place it on a flat surface, taking care not to scratch the lenses or damage the cab

3Mounting Hardware - All mounting hardware is packed in a small box inside the main carton. There are two bracketsand two mounting plates used to moun

4FIGURE 4 FIGURE 5Step 3 Remove the spare tire and place a piece of plywood or boards over the spare tire well (see figure 4). This will provide a mor

5Step 7 Using a 3/8" drill, locate and drill the the hole for the cable in line with the edge of the large rectangular opening in the trunk of th

6FIGURE 15FIGURE 14Step 12 Install the WingMan rear bar by positioning one end in the far back corner of the rear window and carefully bring the other

7The bracket fasteners shown in figure 16 and 17 make excellent hard mountingpoints for radar guns, video cameras, and etc.Caution:Drilling into the

8Wiring InstructionsLarger wires and tight connections will provide longer service life for components. For high current wires it ishighly recommende

9This Product contains high intensity LED devices. To prevent eye damage,DO NOT stare into light beam at close range.LED Light Head Flash PatternPlac