Code-3 Torus Lighthead Bedienungsanleitung PDF herunterladen (Seite 5)

5

Setting Parent / Child Mode

All units shipped will be in the PARENT mode with the factory default,

Cycleash pattern. To change a head to the CHILD mode hold the

White wire to Ground for 5 seconds or more. When in the CHILD mode

the head will need the Grey communications wire connected the PAR-

ENT Grey wire to enable ashing, unless in Steady Burn. Alternatively,

the Grey communications wire of a CHILD can be connected to +12V

to enable ashing during set-up. If communications is lost between the

PARENT/CHILD for over 15 seconds the CHILD head will independently

ash until the communications is restored. A head set to the CHILD mode

can be reset to a PARENT again by holding the White wire to Ground for

5 seconds or longer.

Setting Flash Patterns

To change the ash pattern of any PARENT or CHILD hold the White

wire to Ground for at least 1 second, and less than 3 seconds, and then

release. While holding the White wire to Ground the head will stop ash-

ing until released. Remember that the Grey wire of a CHILD must be

connected to the Grey wire of a PARENT, or to +12V, to enable ashing.

When setting ash patterns, the CHILD will require selecting between Alternating

or Simultaneous patterns, while the PARENT will only require selecting the pat-

tern desired. The tables below show the available ash options and their selec-

tion order for each mode. Simultaneous and Alternating ash patterns are exactly

the same ash patterns but will either alternate or ash simultaneously when

connected to a PARENT. Heads will come from the factory preset to the PARENT

mode with the default Cycleash pattern. When changing a factory preset PAR-

ENT head to a CHILD the head will default to the Alternating Cycleash pattern,

position 1, as shown in the table below:

Flash Pattern Description

1 Alternating Cycleash ( Factory default)

2 Alternating Quadash

3 Alternating Doubleash

4 Alternating Singleash

5 Simultaneous Cycleash

6 Simultaneous Quadash

7 Simultaneous Doubleash

9 Simultaneous Singleash

10 Steady Burn

3-LED Flash Options Available in PARENT Mode

Flash Pattern Description

1 Cycleash (Factory default)

2 Quadash

3 Doubleash

4 Singleash

5 Steady Burn

Note: When using the Cycleash pattern, all heads must be in Cycleash. All ash pat-

terns are 70 fpm.

Code-3 Torus Lighthead Bedienungsanleitung Seite 5

Kommentare zu diesen Handbüchern

Code-3 Torus Lighthead Bedienungsanleitung Seite 5

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Beleuchtung Code-3 Torus Lighthead