Code-3 6 Pack LED Hide-A-Blast Bedienungsanleitung PDF herunterladen (Seite 4)

1. First, carefully plan the installation so that the HB Series LED Lights will not interfere with the mounting or

operation of the vehicle's existing light xtures. Using a 1 inch hole saw, cut a hole in the vehicle's light xture

in a location that will allow the HB Series LED light to be mounted in such a way that it will provide maximum

light inside the reector (see Figure B). Use a deburring tool to remove burrs and to chamfer the edge of the

hole before inserting the HB6PAK. Proper installation will provide an excellent seal and prevent water from

entering the light xture.

Wiring

1. Install the LED light heads in the desired locations.

2. Route the cables between the light heads and the control switch panel. Make sure the cable is secure along

the chosen routing inside the vehicle to prevent damage by chang or binding. Be sure to keep the cables away

from engine hot spots.

3. Secure the cables and the HB Series asher module using plastic wire ties.

Installation and Mounting

The HB Series LED Light components are water resistant but NOT waterproof and should

be located in an area protected from the weather and water.

WARNING!

FIGURE A

1 2 3 4 5 6 7 8

Keine Kommentare

Code-3 6 Pack LED Hide-A-Blast Bedienungsanleitung Seite 4