Code-3 6 Pack LED Hide-A-Blast Bedienungsanleitung PDF herunterladen (Seite 5)

IMPORTANT: To extend the power (+) and ground (-) wires, use the following as a guide.

1 to 10 ft. use 20AWG wire

10 to 50 ft. use 18AWG wire

Pattern Selection Timing

Time Function

0~1 sec NEXT PATTERN / ON

1~3 sec PREVIOUS PATTERN

3~5 sec P19 CYCLE FLASH

>5 sec OFF

FIGURE B

4. For synchronized operation of multiple HB Series lights

the yellow wires from each unit's cable must be connected

together. Insulate this connection using an insulated butt splice

to prevent accidental contact with power or ground.

Connections:

Red +Power (11-30VDC)

Black Ground

Yellow Synchronization

Blue Pattern Selection

The HB6PAK light should be fully inserted into the hole so

that the aluminum heatsink is against the light housing and

the grove of the rubber seal is locked into the hole. This will

provide a secure installation and a highly water resistant

seal.

1 2 3 4 5 6 7 8

Keine Kommentare

Code-3 6 Pack LED Hide-A-Blast Bedienungsanleitung Seite 5