Code-3 6 Pack LED Hide-A-Blast Bedienungsanleitung PDF herunterladen (Seite 6)

FLASH PATTERN SELECTION

FLASH MODE

Any one of the 20 Flash Patterns may be selected by using the blue wire to scroll through the pat-

terns. Touch the blue wire to ground for about 1 second and then remove it. The ash pattern will

switch to the next pattern. When the yellow wires (SYNC) from each light are connected, lights

with Phase 1 patterns selected will ash in an alternating sequence with lights that have a Phase 2

pattern selected. The following patterns are available.

Description

1. signal alert alternating (Factory Default)

2. signal alert simultaneous phase1

3. signal alert simultaneous phase2

4. rapid ash alternating

5. rapid ash simultaneous phase1

6. rapid ash simultaneous phase2

7. single ash 75 alternating

8. single ash 75 simultaneous phase1

9. single ash 75 simultaneous phase2

10. single ash 375 alternating

11. single ash 375 simultaneous phase1

12. single ash 375 simultaneous phase2

13. action ash alternating

14. action ash simultaneous

15. modul ash alternating

16. modul ash simultaneous

17. action scan

18. STEADY

19. Cycle Flash

20. off

1. Connect the Power/Control wire harness assembly to a switch. To select one of the 30 different ash func-

tions, turn the light on and touch the bare end of the blue wire to ground for about one second. You can also

scroll backward through the ash pattern table (see the PATTERN SELECTION TIMING section for complete

details. Repeat this process until you reach the desired ash pattern. After you have selected the desired

ash pattern, you should cover the bare end of the blue wire with heat shrinkable tubing to prevent an ac-

1 2 3 4 5 6 7 8

Keine Kommentare

Code-3 6 Pack LED Hide-A-Blast Bedienungsanleitung Seite 6