Code-3 Matrix Bedienungsanleitung

1 INSTALLATION MANUAL Introduction ...

10 3x5 and XT-3 Installation Into Stainless Steel Enclosure Stainless steel enclosures are available in single, double, and triple stack (see page

11 3. Attach conduit and fitting through hole in the rear of the stainless steel enclosure and secure with nut. Make sure conduit and fitting are in

12 Attaching 3x5 and XT-3 to the Harness 1. Install the XT-3 using the supplied brackets to match the stainless steel enclosure. 2. Install black ad

13 4. Attach the 3x5 connector to the 3x5 harness previously fed through the vehicle. 5. Set 3x5 Lens, PCB, and Heat Sink onto black adapter plate.

14 6. Put four sheet metal screws (#6) through the chosen lens, through the heat sink, and into the black adapter plate. 7. Repeat step 3 through 5

15 Overhead Lighting Installation (ex. DuoBeams or Lightbars) Overhead lighting of the Matrix System has multiple choices. This includes various lig

16 Additional Lighting Installation (ex. Smart 3x5, Arch Beacon, etc.) If a smart light head is to be sync’d with the system, power, ground, and sync

17 Replacement Parts Central Controller S25808 – Central Controller in Enclosure with Power Harness and Control Harness Complete 3x5s with Lens, Sili

18 Notes:

19 Notes:

2 Product Patents Apply for the Matrix System For U.S. Patent Nos. See https://secure.code3pse.com/patents/ Introduction The Matrix System is designed

20 NEED HELP? Call our Technical Assistance HOTLINE - (314) 996-2800 Code 3®, Inc. 10986 N. Warson Rd. St. Louis, Missouri 63114-2029 USA Install

3 General Wiring Matrix System Wiring • Read through the wiring instructions for the Matrix System prior to the installation and become fully familiar

4 General Wiring (continued) • If Chassis Ground must be used, connection points should be clean and have paint or coatings removed to insure a good t

5 Wire Gauge Selection General Harnessing Instructions Once all the products in the Matrix System have been chosen and located in the vehicle, harn

6 Control Harness Connections Below is a picture of the control wire. This should be already connected to the Matrix System Central Controller inside

7 Control Harness Connections (continued) Below is a picture of the control wires properly connected to the Matrix System Central Controller. Green

8 Power Harness Connections Below is a picture of the power wire. This should be already connected to the Matrix System Central Controller inside the

9 Final Harness Connections Below is a picture of how the product will arrive. The only connections remaining will be for the customer to install the