Code-3 21TR & 21TR Plus Bedienungsanleitung Seite 1

1INSTALLATION& OPERATION MANUAL21TRTM AND 21TR PLUSTM LIGHTBARRead all instructions and warnings before installing and using.INSTALLER: This man

10Fusing - 21TR PlusTMThe light bar should be installed with an external fuse or circuit breaker in the RED lead of the 2 conductor 10 AWG power cable

11Notes: *When the ArrowStik® Left and ArrowStik Right wires are both connected to +power, the Center-Out ArrowStik function is activated.**When the P

12ArrowStik® Pattern SelectionThe 21TR Plus™ is designed to offer user selectable traffic directing signals and traffic warning options

13Steady Burn Setting - 21TR PlusTM The Steady Burn feature allows up to two (2) of the light bar's light heads to be designated to operate in St

14Take Down and Alley LightsAlley LightsLocated at the ends of the light bar to provide light to the side of the vehicle. Stationary Lamps/Takedown L

15Take Down and Alley Light Flash Mode - 21TR PlusTMThe Take Down and Alley Lights can be programmed to ash at different rates. Reference Table 6.

16MaintenanceLens CleaningUse plain water and a soft cloth, or Code 3® lens polish and a very soft paper towel or facial tissue. Because plastic scr

17 Parts List & Exploded View(Reference numbers identify items shown in Figure 11)Ref No. Description Part No. 1 Bottom Outboa

18WARRANTY Code 3®, Inc.’s emergency devices are tested and found to be operational at the time of manufacture. Provided they are installed and o

2IntroductionThe 21TR™ & 21TR PlusTM Light Bar is a light bar that is approximately 2" high, yet delivers unobstructed 360° warning and more

3Installation & MountingMounting HardwareAll mounting hardware is packed in a small box inside the main carton. Four standard kits are available:

4Mounting Bracket5/16-18 Carriage BoltCustomer Supplied BoltPlastic Shim (if needed)Rubber Foot5/16" NutFIGURE 3Bottom of LightbarNOTE: Tighten o

5Wiring InstructionsBefore attempting to connect wiring refer to wire tag attached to the lightbar's main cable. Each wire in the cable controls

6Fusing - 21TRTMThe light bar should be installed with an external fuse or circuit breaker in the RED lead of the 11 conductor cable. The recommended

7Factory Defaults - Flash PatternsFind below the seven default ash patterns for the various combinations of wires. Reference Table 2 for all ash p

8Progressive vs. Independent SwitchingIn a 3-level progressive switch application there are only 3 patterns that typically need to be set.Example 1:

9Setting Flash PatternsStep 1Power-up the light bar by connecting the Red wire to +12V and the Black wire to ground, and select Level 1 on a user-purc